Phased array ultrasonic inspection of large forged steel blocks (more than 30 inches in each direction) is very challenging because of the long propagation distances and the variations in the material properties along the propagation axis. In addition, common phased array ultrasonic testing methods such as beam focusing are not suitable because the size of the focused area is very small compared with the dimension of the part under inspection. The Total Focusing Method (TFM) associated with the Full Matrix Capture (FMC) acquisition scheme is therefore appropriate in this scenario. In this work, the material properties were studied and used to design a transducer optimized for the inspection large parts. Elements size and number was a strong concern because of the natural focus of FMC and the large amount of data generated and treated for TFM reconstruction. The aim was to minimize the amount data to be processed in order to perform live imaging with a minimal compromise on the resolution. Emission sequences and reconstructions were optimized to increase Signal to Noise Ratio (SNR). Finally, live imaging of 1/16” Side Drilled Holes in a 30-inch forged steel block was performed. For each reflector, the 6-dB drop extent was lower than 0.2” in the axial direction and 0.5” in the lateral direction. The SNR was more than 32 dB and the maximum value of 54 dB was measured at the middle of the block also corresponding to the natural focus of the probe in elevation.
1. Olympus, N. Introduction to Phased Array Ultrasonic Technology Applications. D Tech Guideline”, Olympus NDT 2004.
2. Holmes, C.; Drinkwater, B.; Wilcox, P. The Post-Processing of Ultrasonic Array Data Using the Total Focusing Method. Insight-Non-Destructive Testing and Condition Monitoring 2004, 46 (11), 677–680.
3. Long, R.; Russell, J.; Cawley, P. Ultrasonic Phased Array Inspection Using Full Matrix Capture. Insight - Non-Destructive Testing and Condition Monitoring 2012, 54 (7), 380–385. https://doi.org/10.1784/insi.2012.54.7.380.
4. Le Jeune, L.; Robert, S.; Lopez Villaverde, E.; Prada, C. Plane Wave Imaging for Ultrasonic Non-Destructive Testing: Generalization to Multimodal Imaging. Ultrasonics 2016, 64, 128–138. https://doi.org/10.1016/j.ultras.2015.08.008.
5. Dupont-Marillia, F.; Jahazi, M.; Lafreniere, S.; Belanger, P. Design and Optimisation of a Phased Array Transducer for Ultrasonic Inspection of Large Forged Steel Ingots. NDT & E International 2019, 103, 119–129. doi.org/10.1016/j.ndteint.2019.02.007.
6. NDT/NDE Vantage Product Information, Accessed on 15th October 2019, https://Verasonics.Com/Wp-Content/Uploads/2019/04/Vantage-Platform-for-Materials-Science-and-NDENDT-Research.Pdf
7. Dupont-Marillia, F.; Jahazi, M.; Lafreniere, S.; Belanger, P. Influence of Local Mechanical Parameters on Ultrasonic Wave Propagation in Large Forged Steel Ingots. J Nondestruct Eval 2019, 38 (3), 73. doi.org/10.1007/s10921-019-0611-8.
190 Page Views
0 PDF Downloads
0 Facebook Shares