Article Article
Nondestructive Assessment of FRP-Concrete Bond

Acoustic testing and thermal imaging are widely used methods for evaluating FRP-concrete bond. This study assessed the performance of these methods by comparing predictions of good or bad bond in newly wrapped specimens against measured values subsequently obtained at the same locations from destructive pull-off tests. To ensure consistency, acoustic tests were conducted using an instrumented swing hammer with a fixed drop height. This meant that the same force was applied at each test location. Though many commercial thermal imaging systems are available, for the precision required in detecting bond problems they are costly. For this reason, USF developed a Depth Encoder-Infrared Thermocouple (DEIT) system that can achieve similar results but at a fraction of the cost. The DEIT system was custom-built to obtain quantitative information on the size and location of the suspected areas of poor bond in the prestressed concrete pile specimens evaluated. It operates like a scanner where a strip of high intensity light is passed over a page directly adjacent to an array of light receptors. DEIT uses a 500W strip-type heat lamp in combination with a line of ten infrared detectors to measure surface temperature. Destructive pull-off tests were conducted on full-size pile specimens where the FRP had been applied to dry and wet surfaces using pressure vacuum bagging. The intent was to establish the relative merits of these systems compared to applications were no pressure was applied. Results showed that by and large acoustic testing and thermal imaging gave comparable results when evaluating bond in newly applied FRP.

1. ACI 440.2R-08 (2008). Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures, ACI, Farmington Hills, MI. 2. Aguilar, J., Winters, D., Sen. R., Mullins, G. and Stokes, M. (2009). “Improvement in FRP-Concrete Bond by External Pressure”. Transportation Research Record, No. 2131, pp. 145-154. 3. ASTM D4541 (2002). Test Method for Pull off Strength of Coatings Using Portable Adhesive Tester. 4. Kaiser, H and Karbhari, V.M. (2004). “Non-destructive testing techniques for FRP rehabilitated concrete – II: an assessment”. International Journal of Materials and Product Technology, Vol. 21, No. 5, 385-401. 5. Liu, J. and Vipulanandan, C. (2005). “Tensile Bonding Strength of Epoxy Coatings to Concrete Substrate”. Cement and Concrete Research, Vol. 35, pp. 1412-1419. 6. Sen, R., Shahawy, M., Mullins, G., and Spain, J. (1999). “Durability of CFRP/Concrete Epoxy Bond in a Marine Environment,” ACI Structural Journal, Vol. 96, No. 6, pp. 906-914.
Usage Shares
Total Views
52 Page Views
Total Shares
0 Tweets
0 PDF Downloads
0 Facebook Shares
Total Usage