Article Periodicals » Materials Evaluation » Article
Ultrasonic Nondestructive Optimization for Development of Resin Infusion Process Composite Co-cured Wing

After considerable experience with the development of pre-impregnated composite fiber-based (carbon uni-directional pre-impregnated composite fiber) autoclave molded carbon epoxy composite airworthy components for both military and civilian aircraft programs, a new technology was developed called resin infusion technology (RIT) to manufacture a co-cured carbon composite wing for civilian aircraft.

References
ASTM, ASTM D2734-09, Standard Test Methods for Void Content of Reinforced Plastics, ASTM International, West Conshohocken, Pennsylvania, 2009. Biswas, C. and A. Venkoba Rao, “Acceptance Standard for Carbon Fiber Composite Components,” ADS, Vol. 32, December 1998. Kruckenberg, T. and R. Paton (eds.), “Resin Transfer Moulding for Aerospace Structures,” Characterization & Evaluation of Materials, Springer, New York, New York, 1999, p. 548. Ramachandra, H. V., S. Ravi and M. V. E. Moorthy, “Quality Assurance (QA) Document for Composite Components of LCA,” NAL SP 9810, National Aerospace Laboratories, July 1998. Seetharam, S. A., R. Sundram, P. Ravikumar, M. R. Madhava and M. S. Rao, “Quality Assurance of LCA Composite Wing Spars,” NAL PD ST 9431, National Aerospace Laboratories, December 1994. Sudheendra, H. N., M. R. Madhava and M. S. Rao, “Non-Destructive Evaluation of Composite Components for SARAS: Acceptance Criteria,” TB-01, Vol. 38, December 2000. Sudheendra, H. N., M. R. Madhava, M. S. Rao, S. A. Seetharam, R. Sundram, J. Prasad, S. A. Vaneswaran and N. S. Rao, “Quality Assurance of LCA Composite Rudder,” NAL PD ST 9424, National Aerospace Laboratories, September 1994. Sudheendra, H. N., S. A. Seetharam, R. Sundram, M. N. N. Gowda, M. R. Madhava and M. S. Rao, “Quality Assurance of Co-cured Composite Fin for LCA,” NAL PD ST 9508, National Aerospace Laboratories, May 1995. Sundram, R. and M. S. Rao, “Fabrication of High Performance Composites by Vacuum Enhanced Resin Infusion Technology,” 3rd International Conference on Composites, Indian Society for Advancement of Materials and Process Engineering, 7 – 9 October 2004. Sundram, R., M. K. Gaddikeri, K. K. Verma, K. Singh, B. L. Dinesh and M. S. Rao, “Tooling concepts for the VERITy Process,” 5thInternational Conference on Composites, Indian Society for Advancement of Materials and Process Engineering, 24 – 25 November 2006. Teufel, P., M. Maxwell and R. Gardiner, “Low Cost Composite for a General Aviation Aircraft Wing,” AIAA/ICAS International Air and Space Symposium and Exposition, 14 – 17 July 2003, American Institute of Aeronautics and Astronautics, Dayton, Ohio.
Metrics
Usage Shares
Total Views
23 Page Views
Total Shares
0 Tweets
23
0 PDF Downloads
0
0 Facebook Shares
Total Usage
23